How To Repair Torn Shingle
Easy Shingle Repair
Updated: Jun. thirty, 2022
Set up those potential leaks now.
Remove those ugly damaged shingles and stop potential roof leaks by following this simple three-step shingle replacement process.
You might also like: TBD
Supervene upon damaged shingles
Photo 1: Pry gently to break shingle free
Gently tap a flat bar under the shingles to pause the seal-down strips free. Don't forcefulness it—shingles rip easily.
Strip out photo of single shingle showing nail locations
Observe all eight nails in these typical locations.
Photo 2: Pry up shingle and nail together
Wedge the notch of the pry bar under the shingle at the nail head, then pry upwards both shingle and smash.
Photograph 3: Smash on the new shingle
Nail downward the new shingle, propping the tabs higher up as you nail to avert breaking them.
A broken shingle is both ugly and a leak waiting to happen. Only as long as you can find matching shingles (and you're not afraid of heights), the repair is straightforward.
Pick a solar day when the weather is moderate to do the repair—also cold and the shingles can crack; too warm and the shingle sealants are tough to break.
Loosen the tabs under the broken shingle and the side by side 2 courses above it (Photo one). Shingles are fastened with viii nails each—four at the center just above the tab slots and four through the shingle above it—and you take to elevator up all the shingles that cover those nails to remove them.
After all the tabs are loose, push the flat bar up nether the damaged shingle to each nail, centering the nail in the flat bar notch (Photo 2). To avoid ripping shingles, gently work the pry bar under both tabs every bit you push it up.
Pop out the nails by prying underneath the shingle instead of trying to dig the nail caput out from the height of the shingle; that will wreck the shingle. Then push the shingle down from the nail head and pull out the blast. Afterwards removing the center row of nails on the damaged shingle, elevator the undamaged shingles above it and remove the adjacent row of nails. Then pull out the damaged shingle.
Slide the new shingle up into place. Nail the centre row beginning, and so the center row of the course in a higher place information technology, nailing 1/two in. over from the old holes (Photo 3). Nail at the top of the slots between the tabs, just above the sealant strip.
Required Tools for this Project
Accept the necessary tools for this DIY project lined up before you start—yous'll save time and frustration.
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready alee of fourth dimension. Here's a list.
Originally Published: June 20, 2022
Source: https://www.familyhandyman.com/project/easy-shingle-repair/
Posted by: chamberlainbersoones.blogspot.com
0 Response to "How To Repair Torn Shingle"
Post a Comment